42 Sending Faxes
Sending a Fax Using the Original Glass
1 Press the Fax key to enter Fax mode.
" If the initial mode (UTILITY - MACHINE SETTING - INITIAL MODE) is
set to FAX, this step can be skipped.
2 Remove all documents from the ADF.
" If you are using the original glass to scan, do not load any documents into
the ADF.
3 Lift to open the ADF cover.
4 Place the original document face down on the original glass and align the
document on the scales above and to the left of the original glass.
5 Gently close the ADF cover.
" Closing it too quickly may cause the document to move on the original
glass.
" Take care not to trap your fingers when closing the ADF cover.
6 Adjust the document image quality.
" For details on adjusting the document image quality, refer to “Adjusting
the Image Quality” on page 44.
7 Specify the fax number of the recipient in one of the following ways:
– Direct dialing
– Using the favorite list
– Using the Speed Dial function
– Using the Group Dial function
– Using the Phone Book functions
– Using the Redial/Pause key
" For details on specifying the recipient, refer to “Specifying a Recipient” on
page 45. For details on using the Redial/Pause key, refer to “Using the
Redial Function” on page 49.
" A transmission can also be sent to multiple recipients with the Broadcast
function. For details on sending a broadcast transmission, refer to “Send-
ing a Fax to Multiple Recipients (Broadcast Transmission)” on page 49.
8 Press the Start key.
A screen appears, requesting confirmation of the scanning area.
9 To scan the displayed scanning area, press the Enter key. The document is
scanned.
