36 Control Panel and Configuration Menu
Specifying Settings in the Utility Menu
General Procedure for Specifying Settings in the Utility
Menu
1 Press the or key to select UTILITY, and then press the Enter key.
2 Press the or key to select the desired menu, and then press the Enter
key to display the selected menu.
" Refer to the menu configuration on page 1-18 to display the desired
menu.
3 To select a setting, press the , , or key.
To enter a setting, use the keypad to type in the number.
4 Press the Enter key.
The setting is applied.
" To cancel the settings, press the Back key.
Memory Reception
Received faxes can be stored in the memory and printed at a specified time. This
is convenient, for example, when confidential documents are received.
Memory reception can be used with the following settings.
Start/end time settings: Not set
MEMORY RX MODE function is normally set to ON. To print a fax saved in
memory, set MEMORY RX MODE function to OFF.
Start/end time settings: Set
Memory reception mode begins and ends at the specified time.
Example 1: When ON TIME setting is set to 18:00 and OFF TIME setting is
set to 8:00
The machine is in memory reception mode from 18:00 to 8:00 and in nor-
mal reception mode, where faxes are printed after being received, from
8:00 to 18:00.
Example 2: When ON TIME setting is set to 12:00 and OFF TIME setting is
set to 12:00 (the start time and end time are the same)
MEMORY RX MODE function is normally set to ON; however, faxes
saved in memory are printed at 12:00.
