A SERVICE OF

logo

13
10
Four headless screws need to be
removed from the high frequency driver.
Pliers could help if the screws are too
tight. Turn counter-clockwise to loosen
and remove, clockwise to tighten. Keep
the four headless screws in a safe place.
Place the new high frequency driver
(part #0008093) where the old one
was. Follow the same steps as above,
but backwards 10 to 1. Power up the
SR1522z and the new driver should now
be pumping out those highs again.
Fantastic, you just replaced a high
frequency driver!
High Frequency Driver replacement continued:
1
2
3
4