A SERVICE OF

logo

Repair Information 4-43
5055-01x
Power Supply 1 Removal
1. Open the top unit and remove the RIP cover, RIP board, RIP
box, and electronic box. Remove the cassette, left front cover,
and back cover. Remove the left side cover.
2. Remove the insulation sheet connector, two ground wires, five
screws, two screws with washers, two screws with spring
washers and remove the power supply. (When installing, incline
the ground wire by 45 degrees.
Service.bk Page 43 Thursday, October 4, 2001 12:20 PM