Laney
OPERATING INSTRUCTIONS
Laney
OPERATING INSTRUCTIONS
Page 16 /20
0V
H
1
0R
General Notes
Amplifier connection: In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off your
equipment. With all system parts connected, turn on source equipment, tape decks, cd players, mixers, effects processors etc.
BEFORE turning on your guitar amplifier. Many products have large transient surges at turn on and off which can cause damage to
your speakers. By turning on your guitar amplifier LAST and making sure its Volume controls are set to minimum any transients
from other equipment will not reach your loudspeakers. Wait until all system parts have stabilised; usually a couple of seconds.
Similarly when turning off your system always turn down the Volume controls on your guitar amplifier and then turn off its power
before turning off other equipment.
Cables: never use shielded or microphone cable for any speaker connections as this will not be substantial enough to handle the
amplifier load and could cause damage to your amplifier system.
Caution: These professional loudspeaker systems are capable of generating very high sound pressure levels. Use care with
placement and operation to avoid exposure to excessive levels that can cause permanent hearing damage. (Refer to guidelines on
page 2)
Servicing: The user should not attempt to service these products. Refer all servicing to qualified service personnel.
CAUTION
RISK OF ELECTRIC SHOCK DO NOT OPEN
SUPPLY VOLTAGE
HT FUSE
CAUTION
TO REDUCE THE RISK OF FIRE REPLACE
ONLY WITH SAME TYPE AND RATING
MODEL
SERIAL NO.
1*16 OHM
MAXIMUM POWER CONSUMPTION
300 WATTS
WARNING - THIS APPARATUS MUST BE EARTHED
WARNING - TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION - TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER. NO USER SERVICABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE PERSONEL.
ATTENTION REMPLACER LE FUSIBLE PR LE MEME
ET CALIBRE
ATTENTION DEBRACHER A LA PRISE SECTEUR AVANT D’OUVRIR
MADE IN THE U.K.
www.laney.co.uk
Laney
Power To The Music
T1A L
MAINS FUSE
~220-240V = T2A L 250V
~100-120V = T5A L 250V
1*8 OHM 1*4 OHM
2*16 OHM
2*8 OHM
LOUDSPEAKERS
WARNING:
USE ONLY ONE IMPEDANCE
SELECTION AT A TIME
CLASS 2 WIRING MAY BE USED
INOUT
LINE
PREAMP POWERAMP
FOOTSWITCHEL34 6L6/
5881
BIAS
ONLY FOR USE
WITH LANEY FS4
INSERT
RETURN
LEVEL
RETURNSEND
BYPASS SIDE/
CHAIN
INSERT
SENDRETURNRETURNRETURN
EFFECTS LOOPEFFECTS LOOP
OVERDRIVE CHANNEL BCLEAN CHANNEL A
A+B
SEND
0 10
VH100R SAMPLE SYSTEM 1
8 Ohms
Link
Model RB115
Power Rating 300W Program
Model RB115
Power Rating 300W Program
Serial Number:Serial Number:
Input
Laney
Power To The Music
www.laney.co.uk
DESIGNED IN THE UK BY LANEY
16 Ohms
Link
Model RB115
Power Rating 300W Program
Model RB115
Power Rating 300W Program
Serial Number:Serial Number:
Input
Laney
Power To The Music
www.laney.co.uk
DESIGNED IN THE UK BY LANEY
SAMPLE
GS412IA
Input
FX Controller
GS412IA 16 Ohm
Output
Connected to the single
16 ohm socket.
Sidechain Mode
Return level active for
mix level
