Page 10 of 19 2452-222/2452-422/2452-522 - Rev: 1/21/2014 7:50 AM
1) Press and hold controller button until it beeps
Controller LED will start blinking green
2) Tap controller set button
Controller LED will start double-blinking green
3) Tap DIN Rail on and adjust to desired scene brightness
DIN Rail LED will be green
4) Press and hold DIN Rail set button until it double-beeps
5) For each additional scene member:
a. Adjust member to desired scene brightness
b. Press and hold set button until it double-beeps
6) Tap On, Off or the Set button once to exit Multi-linking
Controller LED will stop blinking
7) Test by tapping controller button on and off
DIN Rail and other scene responders will all respond appropriately
Make DIN Rail a Controller of Multiple Responders
1) Press and hold DIN Rail set button until it beeps
DIN Rail LED will start blinking green
2) Tap DIN Rail set button
DIN Rail LED will start double-blinking green
3) For each responder you are adding:
a. Adjust responder to desired scene brightness/state
b. Press and hold set button until it double-beeps
4) Tap On, Off or the Set button once to exit Multi-linking
DIN Rail LED will stop blinking
5) Test by tapping DIN Rail on and off
All the responders will turn on and off
Remove DIN Rail as a Controller (Unlink)
If you no longer want DIN Rail to control another device (or are removing DIN Rail) it is important that you follow the
instructions below for each responder.
1) Press and hold DIN Rail set button until it beeps
DIN Rail LED will start blinking green
2) Press and hold DIN Rail set button until it beeps a second time
DIN Rail LED will start blinking red
3) Press and hold responder set button until it double-beeps
DIN Rail will double-beep and LED will stop blinking
4) Test by tapping DIN Rail on and off
Former responder will not respond
Remove DIN Rail as a Responder (Unlink)
If you no longer want a controller button to control DIN Rail follow these directions. Note: If you ever wish to un-install
DIN Rail, remove all DIN Rail responder links, otherwise controllers will retry commands repetitively, creating network
delays
1) Press and hold controller button until it beeps
Controller LED will start blinking green
2) Press and hold controller button until it beeps a second time
Controller LED will start blinking red
3) Press and hold DIN Rail set button until it double-beeps
Controller LED will stop blinking
4) Test by tapping controller button on and off
DIN Rail will no longer respond
Remove DIN Rail as a Controller of Multiple Responders (Unlink)
1) Press and hold DIN Rail set button until it beeps
DIN Rail LED will start blinking green
