Document 800-07422 Rev A 21
08/10
Using the UltraKey Lite Controller
You may need to learn how to use the UltraKey Lite both before and after you begin
configuring. In this section:
• Logging Onto the Controller, page 21
• Using the UltraKey Lite to Navigate the LCD Menus, page 22
• VideoBloX Key Functions, page 24
• MAXPRO Key Functions, page 27
Note Key availability is dependent on the mode selected. Functions only used with
the Standalone Mode (for PTZ/DVR functions) are not described in this
document and will be included in future releases.
Logging Onto the Controller
1. Connect the keyboard with a power adapter (12V (±10%) DC/1 A included) or a
network cable with PoE.
2. To configure the main menu settings, press Alt > Clr.
3. Enter the PIN password 3434.
Note If an invalid password is entered, a message displays and the controller
buzzes. Repeat the steps to log on.
When you are in the Password menu, press Alt > Clr again to exit the
Password menu.
