A SERVICE OF

logo

Ch 3: Installing Optional Devices
Hitachi PC VisionBase8450H/R Server 79
1. Connect internal SCSI cables (for hard disk) onto the disk array controller board.
NOTE: See “Installing PCI Boards” on page90 for installing a disk array controller board.
Internal SCSI cables (for hard disk) are connected onto the hard disk platter board behind extended
storage bays 1 to 6.
An internal SCSI cable (for removable device) has already been connected to the master board.
2. Connect internal SCSI cables (for removable device) and power cables with SCSI devices on extended storage
bays 7 to 9. Also, connect an FDD cable and FDD power cable with the floppy disk drive.
NOTE: An internal SCSI cable (for removable device) has already been connected to the master board.
Use the power cables provided in the lower portion of the system equipment. Unclamp and remove the
cables from there, then connect them to the SCSI device.
An internal DAT changer requires two power cables. (It does not operate if only one power cable is
connected.)
Internal SCSI cable
(for hard disk)
Disk array controller board:
Expansion slot (PCI)4
Internal SCSI cable
(for removable device)
Power cable
FDD power cable
FDD cable