Ch 4: System Environment Settings
112 Hitachi PC VisionBase8450H/R Server
Returning the Settings to Defaults
This section explains how to return the settings to defaults and what action to take when you cannot start the utility.
Read this section as required.
Returning the Settings of the Setup Information to Defaults
Referring “What You Can Do on the Exit Menu”, return the settings of the Setup information to defaults. After that,
be sure to change the settings against “List of Utility Settings” on page113.
Returning the SSU Settings to Defaults
[Method 1] Returning specific boards to defaults
To return the master board settings to defaults
Referring to “List of Utility Settings” on page113, return each of the settings to defaults.
To return ISA board settings to defaults
If you remove an ISA board referring to “Removing ISA boards” on page95, and then install that ISA board
according to “Installing ISA Boards” on page94, the settings will be returned to defaults. If there is a conflict
between resources, the SSU automatically set to a value other than the default to avoid the conflict.
To return PCI board settings to defaults
1. Turn off the system equipment.
2. Remove all PCI boards from the slots.
3. Start the SSU.
4. After saving the settings on [Resource Configuration Add-in] in the SSU, terminate the SSU, then turn off the
system equipment.
5. Reinsert the PCI boards into the slots.
6. Turn on the system equipment, then start the SSU. PCI board settings are automatically returned to the defaults.
[Method 2] Returning all settings to defaults
Unless you have reserved default settings as an SBF file, take the following steps:
1. Referring to “Removing extended boards” on page93, remove all PCI and ISA boards.
2. After starting the SSU, save the settings by pressing the [Save] button in “Resources”.
3. Referring to “List of Utility Settings” on page113, check all items and make necessary settings.
4. Reinsert the ISA boards in the slots, then referring to “Installing Extended Boards” on page90, install the ISA
boards.
5. Reinsert the PCI boards in the slots.
6. After starting the SSU, save the settings by pressing the [Save] button in “Resource”.
For utility settings for extended boards, refer to the manual attached to each extended board.
