Contents
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-001
xi
E. FastPath Tasks: Required
E. FastPath Tasks: Required
1. Install Hardware E-3
1. Inventory Shipment E-4
2. Collect Tools E-6
3. Unpack and Unload Server E-6
4. Connect Groundstraps E-10
5. Inventory and Inspect All Components E-11
6. Connect the Power-On Cables E-11
7. Connect Emergency Power-Off (EPO) Cables E-13
8. Connect ServerNet Cables E-14
9. Install Service-Side Enclosure Doors If Necessary E-15
10. Install Primary System Console E-16
11. Create Emergency Repair Disk or Automated System Recovery Disk E-18
12. Install Ethernet Switch E-18
13. Connect Ethernet Switch to Group 01 E-18
14. Connect Primary System Console to Ethernet Switch E-19
15. Install Tape Drive E-19
2. Start the System E-22
1. Prepare for System Startup E-22
2. Power On External System Devices E-23
3. Connect AC Power Cords E-24
4. Apply Power to Server E-26
5. Verify Topology E-27
6. Verify System Components E-28
7. Start System E-28
3. Verify the System E-30
1. Verify Components E-30
2. Verify Critical System Processes E-31
3. Verify Disk Drives E-31
4. Verify Tape Drive E-32
5. Verify Firmware E-32
6. Verify State of the Internal ServerNet Fabric E-32
4. Configure the System E-33
1. Configure Passwords E-34
2. Configure Kernel-Managed Swap Files E-35
3. Configure OSM or TSM Environment E-36
4. Configure System Attributes E-37
5. Configure DSM/SCM E-41
5. Install the Backup System Console E-45
