9. Put the blue stop on to the upper end of the spindle, and push it towards the end of the roll.
10. Slide the lever-lock to the locked position.
11. Lift the loading table to ease the spindle into the printer.
CAUTION: To avoid trapping your fingers, do not push the roll with your hands.
If you regularly use different substrates, you can change rolls more quickly if you pre-load rolls of different
substrates on different spindles. Extra spindles are available for purchase.
Load a roll into the printer
To start this procedure, you need to have a roll loaded on the spindle. See Load a roll onto the
spindle on page 16.
The normal minimum substrate width is 23 inches (584 mm). To load substrates down to a minimum
width of 10 inches (254 mm), go to the front panel and select the
icon, then select Substrate handling
options > Enable narrow substrate. With this option, print quality is not guaranteed.
ENWW Load a roll into the printer 19
Handle the substrate
