time required to perform the specific tasks iden-
tified for the maintenance functions authorized in
the maintenance allocation chart. Subcolumns of
column 4 are as follows:
C – Operator/Crew
O – Organizational
F – Direct Support
H – General Support
D – Depot
e. Column 5, Tools and Equipment. Column 5
specifies by code, those common tool sets (not in-
dividual tools) and special tools, test and support
equipment required to perform the designated func-
tion.
f. Column 6, Remarks. Column 6 contains an
alphabetic code which leads to the remark in Section
IV, Remarks, which is pertinent to the item oposite
the particular code.
D-4. Tool and Test Equipment Requirements
(Sec Ill)
a. Tool or Test Equipment Reference Code. The
numbers in this column coincide with the numbers
used in the tools and equipment column of the MAC.
The numbers indicate the applicable tool or test
equipment for the maintenance functions.
b. Maintenance Category. The codes in this
column indicate the maintenance category allocated
the tool or test equipment.
c. Nomenclature. This column lists the noun name
and nomenclature of the tools and test equipment
required to perform the maintenance functions.
d. National/NATO Stock Number. This column
lists the National/NATO stock number of the
specific tool or test equipment.
e. Tool Number. This column lists the manufac-
turer’s part number of the tool followed by the
Federal Supply Code for manufacturers (5-digit) in
parentheses.
D-5. Remarks (Sec IV)
a. Reference Code. This code refers to the ap-
propriate item in section II, column 6.
b. Remarks. This column provides the required
explanatory information necessary to clarify items
appearing in section II.
D-2
