A SERVICE OF

logo

Open as PDF
next previous
Removal and replacement procedures 30
4.
Remove the SAS cable.
To replace the component, reverse the removal procedure.
Hard drive backplane
To remove the component:
1.
Power down the server blade (on page 23).
2.
Remove the server blade (on page 23).
CAUTION: Remove all hard drives and hard drive blanks before removing the hard drive
backplane.
3.
Remove all hard drives ("Hard drive" on page 25).
4.
Remove all hard drive blanks ("Hard drive blank" on page 24).
5.
Remove the access panel ("Access panel" on page 24).
6.
Remove the SAS cable ("SAS cable" on page 29).