A SERVICE OF

logo

2-6
Installing the Switch
Installation Procedures
Installing the Switch
4. Tighten the captive screws. Refer to the yl Module Installation Guide for
more details.
Figure 2-1. Installing a yl module
Caution For proper cooling and reduction of electromagnetic emissions, ensure a slot
cover is installed on any unused slot.
3. Install or Remove a Transceiver (Optional)
Note Hot swapping transceivers is supported. You can install or remove a trans-
ceiver with the switch powered on, a reset will not occur. You should discon-
nect the network cables from the transceivers before hot swapping them.
a. Slide the transceiver in until it stops.
1
Figure 2-2. Installing a fiber optic transceiver.
Align the edges of the board with guides