6Ć20 Removal and Replacement
C4699Ć90000
6 Loosely fit, but do not tighten, the washer
and screw to retain the encoder strip.
Torx-15
Leave
loose
7 Press the encoder spring to the left, and
slip the right end of the strip over the pin.
Press the strip right to the base of the pin
and slowly release the spring.
CAUTION
In the following two steps, avoid distorting
the encoder strip while you tighten it.
8 Replace the washer and nut on the right
side, and slightly tighten the nut.
5.5 mm
Tighten
slightly
9 Slightly tighten the screw on the left side.
Torx-15
Tighten
slightly
10 Slide the carriage back and forth the
length of its travel to ensure free
movement. The encoder strip should not
bind or rub on the carriage.
