A SERVICE OF

logo

Open as PDF
next previous
7GPSMAP 4000/5000 Series Installation Instructions
4. Atthemarkedlocation,usea
3
/
4
in.(19mm)bittodrillaholeforthecabletopassthrough.
5. Fastenthemarinepolemounttotheboat(hardwarenotincluded).
6. Threadthepole-mountbracket
➊
ontothemarinepolemount.
Donotovertightenthebracket.
7. RouteaNMEA2000dropcablethroughthepole-mountbracketandthepole,andconnectthecabletotheantenna.
8. Placetheantennaonthepole-mountbracket,andtwistitclockwise
➌
tolockitinplace.
9. SecuretheantennatothebracketwiththeincludedM3setscrew
➍
.
10.RoutetheNMEA2000dropcableawayfromsourcesofelectronicinterference.
11.ConnecttheantennatoyourNMEA2000network.
12.Aftertheantennaisinstalledonthepolemount,lltheverticalcableslotwithamarinesealant(optional).

notice
When choosing a location to install the under-deck-mounting bracket, make sure the included screws are not too long for the surface thickness. If the screws
are not appropriate for the surface, you must supply the correct length of M4 screws to avoid damage to the top of the mounting surface.
The antenna can be mounted under a berglass surface. Because the antenna has difculty acquiring cellular signals through metal, it is
recommended that you use the under-deck mount under a berglass surface.
1. Identifythemountinglocationontheberglasssurface
➊
,andverifycorrectoperation
atthemountinglocation.
2. Usingtheunder-deck-mountingbracket
➋
asatemplate,markthreepilot-holelocations
➌
onthesurface.
3. Usea
1
/
8
in.(3.2mm)bittodrillthethreemarkedpilotholes.
4. Placetheantennainthebracket,andtwistitclockwisetolockitinplace.
5. SecuretheantennatothebracketwiththeincludedM3setscrew
➍
.
6. Removethebackingfromtheadhesivepads
➎
ontheunder-deckmountingbracket.
7. Makesurethatthebracketalignswiththepilotholes,andadheretheunder-deck
mountingbrackettothesurface.
8. Usingscrewsoftheappropriatelength,fastenthebrackettothesurface.
9. ConnectaNMEA2000dropcabletotheantenna
➏
.
10.RoutetheNMEA2000dropcableawayfromsourcesofelectronicinterference.
11.ConnecttheantennatoyourNMEA2000network.
➌
➊
➋
➎
➏
➍