6-3
Using the Picture Recording Function
Using the Still Picture Recording Function Linked to an External Device
Sample Still Picture Recording Settings
Settings specified on the “Camera Settings” page (→ P.3-11)
Specify the appropriate settings for the VB-C10R being used.
Settings specified on the “Preset Settings” page (→ P.3-15)
Set a camera angle that shoots the open doorway as Preset 1.
Recording conditions to be set (→ P. 3-16)
●Select “Record pictures in response to external inputs”.
●Select “Record still pictures for validated external input events during the Start-Stop times
specified below.”
●Set start time to 17:00:00 and end time to 06:00:00.
●Select all days of the week.
●Select “ON event (OPEN to CLOSE)”.
●At “Pre-event Recording”, set still pictures to be recorded every 1 second, and set “Record
still picture(s) for every specified interval” to 3. With these settings, pictures will be recorded
and stored every second starting 3 seconds before door opens.
* With “Pre-event Recording”, no picture is recorded the instant the input goes ON.
●At “Post-event recording”, set still pictures to be recorded every 1 second, and set “Record
still picture(s) for every specified interval” to 8. With these settings, pictures will be recorded
and stored every second for 7 seconds starting from the instant the door opens.
* With “Post-event Recording”, pictures are recorded from the instant the input goes ON.
●Set position of camera to be used for recording to Preset 1.
* Events occurring during the Post-event Recording are ignored.
