Using Carrier with Base
To attach, line up carrier with base, rear
facing, then push down until positive click
confirms correct attachment (fig. D).
Check installation by lifting carrier from
both ends to verify that both attachment
rods are engaged with the base. Visual
confirmation can be made, using the
button indicator on the rear of the base
(fig. E).
WARNING: Carrier must be attached properly
to the base. When carrier is attached
properly, the green indicator band on the
release button is fully visible (fig. E).
To release, press release button on base,
then lift carrier to remove (fig. F).
IMPORTANT: Always adjust handle to In-
Vehicle position while using in a vehicle.
Basic Base Functions
21
Foot Prop
To use foot prop, press release button and
compress foot prop, then swing foot prop
up from base, into Installation Mode
(fig. A).
WARNING:
•
Always use foot prop when base is
installed in vehicle! Foot prop must be in
Installation Mode for proper carrier
attachment to base.
•
Never use foot prop to raise base above
vehicle seat surface. Doing so will reduce
the stability of the base.
Adjust foot prop height by pressing Foot
Prop Adjust Button while sliding foot prop
to the shortest position that provides
contact with the vehicle floor (fig. B).
To store foot prop for transport outside of
the vehicle, adjust to shortest position, then
collapse into Storage Mode (fig. C). Press
tab into slot on bottom of base to secure.
Basic Base Functions
20
