8
E. Installation
1. Installing the system onto the seat back in a car
(Refer to Figure 3)
Figure 3
1) Unfasten the velcro strap on the rear of the bag. Fold the strap
into the shape of a triangle and fasten it to the bag.
2) Take one of the supplied straps from the lower compartment.
Connect the latch to one of the upper metal rings on the mounting
bag. Connect the “S” hook to the other upper metal ring and place
the loop over the headrest. Adjust the strap until the bag is firmly
secured.
3) Take one of the supplied straps from the lower compartment of
the bag, and connect the latch to the lower metal ring on the left
side of the bag. Attach the "S" hook to the same ring after looping
the strap around the seat rail. Repeat this process for the right
side. In some vehicles, it may be necessary to attach the "S"
connector to the rail directly, as it may not be long enough to reach
back to the ring.
4) Adjust the straps tightly so that the bag is secured.
