Acu-Rite 150 Manual

A SERVICE OF

next previous

• Routethecableswithslackloopstoallowforaxismotion.

• Secureexcesscablebyfasteningwithclipsorties.

• Attachthelinearencoderconnectorstothereadout.

• Movetheaxisandcomparethedisplaytothemovement.

• Movetheaxis20mm(.79”)tocheckreferencemarkoperation.

• Zerothedisplayandindicator.

• Moveaxistotheendofit’stravelreturntodialzero.

• Readoutshouldreadzero±1count.

Checking Your Installation SENC 150

Placedialindicatorattheendofthemoving

component (scale assembly or reading head).

Repeatability Test

Readout

Counting Test

Connecting

Counting Test:

• Congurethereadout’sencoderanddisplayresolution(see

manual).

• Movetheaxisandcomparethedisplaytothemovement.

• Congurereadoutforsensingreferencemarks.

• Moveeachaxisaminimumof20mm(axisdisplayshouldzero).

Repeatability Test:

• Locateanindicatorononeendoftheencoderandzerothe

readout and indicator.

• Movetheaxisthroughthefulltravelandreturntodialzero.

• Readoutshouldreadzero±1count.

Thesestepswillconrmproperoperationofyourinstallation.

The Counting Test conﬁrms proper electrical operation. The

Repeatability Test checks the installation integrity.

Secureexcess

cable

Provideslack

loops

Attachconnector

14

ACU-RITE

®

516291-21_Ve00_SENC_150.indd 16 10/22/2009 10:00:46 AM