A SERVICE OF

logo

Open as PDF
next previous
These steps apply to all spar mounting conditions.
• ACU-RITE
®
bracket kit instructions supercede this section.
• Adjustdrilldepthsandfastenerlengthsasrequired.
• Wheninstructedonpage12:Adjustthelevelingsetscrewsas
follows:
1.Insert,butdonottighten8-32(M4)readingheadscrews.
2.Placea.001”-.003”shimbetweenthelevelingsetscrews
and mounting surface.
3.Adjusteachsetscrewuntilaslightdragisfeltontheshim.
4.Evenlytightenthe8-32(M4)readingheadmountingscrews.
• ContactyourAuthorizedDistributorshouldyourequire
additional assistance.
• Movetheaxistoitscenteroftravel.
• Marktheaxisforquickreturntocenter.
• Determineencodercableexitdirectionandadjust(
see page 3).
• Drill/taptherstendmountinghole/attachthespar.
• Aligntowithin.010”TIR.to-A-,drill/tapsecondendhole.
• Attachthespar/aligntowithin.010”TIR.to-A-.
• Locatethesparwiththeundersideushwiththeaxisparting
line.
• Markoneendmountingholelocation.
Spar Installation Procedure SENC 150
Aligntowithin.010”TIRof-A-
Aligntopofspartowithin
.015”of-A-
-A-=Axistravel
Axispartingline
-A-=Axistravel
1/4-20x1/2”BHCS&
Flatwasher.017”thk.
End mounting hole (typical)
Center mounting axis
Markcenteroftravel
C
L
12
ACU-RITE
®
516291-21_Ve00_SENC_150.indd 14 10/22/2009 10:00:44 AM