Filter
Top Products
24
Setting Auto Power On/Off
The Auto Power function works as described below.
No signal is input and no button is operated for about 30
minutes.
@
The unit enters the Auto Power Off mode.
(The STANDBY indicator flashes slowly.)
@
The unit enters the Auto Power On mode and the power
is turned on automatically when the signal is input*.
(or the power is turned on with p on the remote control
or INPUT selector button on the control center.)
* If the power is turned off and on using POWER on the control
center and the signal is input in STANDBY mode, the power is
turned on after about 5 seconds.
(When a power failure is restored and the signal is input, the
power is also turned on after about 5 seconds.)
You can set the sensitivity for the Auto Power function or
turn the Auto Power function off.
1 Press MENU to display “Auto Power”.
2 To set Auto Power On, select the “Auto Power
2” using MENU +/–. To set Auto Power Off,
select the “OFF” using MENU –.
MENU
0
+–
ENTER
LAST
EFFECT
DSP
SET
AVMUTE
TEST
SUBWOOFER
+
SUBWOOFER
–
NIGHT MODE
231
564
8
MENU
97
0
+–
ENTER
LAST
–
VOL VOL
+
VS10 TV VCR CBL
ON/OFF
CH
CH
MEMORY
The Auto Power function may not work properly depending
on the signal output level of the connected component. In
this case, you can refer to the table described below to
change the sensitivity of the Auto Power function.
Pressing + will change the display from top to bottom,
while pressing – will change the display from bottom to top.
Display Setting/Symptom
OFF The Auto power function is turned off.
1 [Weak signal] Select this position when the unit does
not enter the Auto Power On mode even when the
signal is input, or the unit enters the Auto Power Off
mode even when the signal is being input.
2 [Normal signal] Normally select this position to turn
the Auto Power function on.
3 [Strong signal] Select this position when the unit
enters the Auto Power On mode even when no signal
is input, or the unit does not enter the Auto Power
Off mode even when no signal is input.
After adjusting the menu functions, press MENU. The input
display returns.
MENU
MENU +/–
AV
selector button
The menu functions include: “Auto Power” for setting
automatic power on/off, “Dimmer” for adjusting display
brightness, “Input Name” for naming inputs, “Center
Delay” for adjusting the delay time used for the sound from
the center speaker and “Delay Time” for adjusting the delay
time used for the surround sound.
Adjustments on the menu functions should be performed
with the remote control.
Each time MENU on the remote control is pressed, the
function changes in the following order: “Auto Power”,
“Dimmer”, “Input Name”, “Center Delay”, “Delay Time” ,
and input display.
MENU FUNCTIONS