Filter
Top Products
30
To play a source with the digital sound field processor
2
3
If desired, adjust the delay time and the output level of
each speaker. (For details, refer to the corresponding
descriptions on page 31, 32.)
1
2
Select the desired program that is suitable for the source.
3
JAZZ CLUB
ROCK
CONCERT
CONCERT
HALL
PRO LOGIC
ENHANCED
TV
THEATER
SPORTS
STADIUM
DIGITAL SOUND FIELD PROCESSOR
MOVIE THEATER
70mm
CHURCH
Follow steps 1 - 6 shown in “BASIC OPERATIONS”
on page 21.
The selected program name is shown on the display.
PRO LOGIC
Notes:
• If you prefer to cancel the DSP, press the EFFECT
switch. The sound will be the normal 2-channel stereo
without surround sound effect.
• When STADIUM, ROCK CONCERT, JAZZ CLUB,
CHURCH, or CONCERT HALL is selected, no sound is
heard from the center speaker.
• When a monaural sound source is played with DOLBY
PRO LOGIC or DOLBY PRO LOGIC ENHANCED,
no sound is heard from the front speakers and the rear
speakers. Sound is heard only from the center speaker.
However, if the center channel mode is in PHANTOM,
the front speakers output the sound of the center chan-
nel.
• When this unit’s Dolby Pro Logic Surround system is
used, if the main-source sound is considerably altered by
over adjustment of the BASS or TREBLE controls, the
relationship between the center and rear channels may
produce an unnatural effect.
Dolby Surround AC-3
Dolby Surround AC-3 is the next generation of multi-
channel consumer audio. It uses a low bit-rate audio
encoding scheme, creating a single composite data
stream that contains five high-quality full-range
channels, plus a sixth low frequency effect channel
(called “5.1”).
This unit is equipped with 5 CH DISCRT terminals for
Dolby Surround AC-3.
To listen to a 5 CH DISCRT SOURCE:
Press the LD/TV button so that “5 CH DISCRT”
appears on the display. To cancel it, press the switch
again.
LD/TV
• When you switch to “5 CH DISCRT” mode, the
Digital Sound Field processor features of this unit
are no longer available. The CENTER MODE
switch, DELAY TIME switch and EFFECT switch
also no longer work.
• Signals connected to the 5CH DISCRT INPUT are
not output to the tape decks or video recorders.
To record the signals from an LD player, you must
connect the player to the LD/TV terminals.