Filter
Top Products
96
USING MULTI-ZONE CONFIGURATION
You can select and control Zone 2 by using the control
buttons on the front panel or on the remote control. The
available operations are listed as follows:
• Selecting the input source of Zone 2
• Tuning into FM or AM when “TUNER” is selected as
the input source of Zone 2 (see page 45)
• Tuning into XM Satellite Radio when “XM” is selected
as the input source of Zone 2 (see page 52) (U.S.A.
model only)
• Enjoying music stored on your iPod stationed in a
YAMAHA iPod universal dock (such as YDS-10 sold
separately) connected to the DOCK terminal of this
unit when “V-AUX” is selected as the input source
(see page 98)
y
The volume level and tonal quality of Zone 2 cannot be adjusted.
Adjust the volume control on the amplifier in Zone 2.
You must complete each step while the ZONE2 indicator is
flashing in the front panel display. Otherwise, the Zone 2 mode is
automatically canceled and this unit returns to the normal
operation mode. In this case, repeat the Zone 2 selection
procedure.
■ Controlling Zone 2 with the front panel
1 Press ZONE 2 ON/OFF to turn on Zone 2.
y
ZONE 2 ON/OFF is operational only when MASTER ON/
OFF on the front panel is pressed inward to the ON position.
Once MASTER ON/OFF on the front panel is pressed
inward to the ON position, you can also press POWER or
STANDBY on the remote control to turn on the main zone
and Zone 2 or set them to the standby mode.
2 Press ZONE CONTROL to control Zone 2.
The ZONE2 indicator flashes in the front panel
display for approximately 5 seconds.
3 Rotate the INPUT selector to select the
desired input source while the ZONE2
indicator is flashing in the front panel
display.
• Select “TUNER” as the input source to use the
TUNER features in Zone 2. For details about the
TUNER operations, see “FM/AM TUNING” on
page 45.
• Select “XM” as the input source to use the XM
Satellite Radio features in Zone 2. For details about
the XM Satellite Radio operations, see “XM®
SATELLITE RADIO TUNING” on page 52.
• Select “V-AUX” as the input source to use iPod
features in Zone 2. For details about the iPod
operations, see “USING iPod®” on page 98.
4 Press ZONE 2 ON/OFF to set Zone 2 to the
standby mode.
Controlling Zone 2
Note
ZONE 2
ON/OFF
ZONE
CONTROL
ZONE2
Flashes
INPUT
ZONE 2
ON/OFF