Filter
Top Products
CONTROLS AND FUNCTIONS
3
INTRODUCTION
1 MASTER ON/OFF
Press inward to the ON position to turn on the power of
this unit. Press again to release it outward to the OFF
position to turn off this unit.
See page 14 for details.
Even when this unit is turned off, this unit consumes a small
amount of power to preserve the memory.
2 MAIN ZONE ON/OFF
Turns on Main Zone of this unit or sets it to the standby
mode.
See page
14
for details.
• This switch is operational only when MASTER ON/OFF is
pressed inward to the ON position.
• In the standby mode, this unit consumes a small amount of
power to receive infrared signals from the remote control.
3 ZONE 2 ON/OFF
Turns on Zone 2 or set it to the standby mode. When Zone
2 is turned on, signals are output at the ZONE 2 OUT
jacks.
This switch is operational only when MASTER ON/OFF is
pressed inward to the ON position.
4 ZONE CONTROL
Press to control the input source of Zone 2.
• This button is operational only when Zone 2 is turned on.
• When you press this button, the ZONE 2 indicator flashes in the
front panel display for approximately 5 seconds. Select the
input source of Zone 2 while the indicator is flashing.
• You can select the preset station or channel when TUNER or
XM is selected as the input source of Zone 2.
5 Remote control sensor
Receives infrared signals from the remote control.
Switch the remote control ID between ID1 and ID2 when using
multiple YAMAHA receivers or amplifiers (see pages 35, 36).
6 Front panel display
Shows information about the operational status of this
unit.
CONTROLS AND FUNCTIONS
Front panel
ON/OFF
INPUT
MAIN ZONE
PHONES
BASS
MASTER
SPEAKERS
ON OFF
MD/TAPE MONITORPURE DIRECT
55
1
0
1
44
22
3
3
+
–
VOLUME
l
TUNING/CH
h
ZONE 2 ON/OFF
ZONE CONTROL
FM/AM
XM/ANT
EDIT
SEARCH MODE
A/B/C/D/E
12345678
CATEGORY
MEMORY
MAN'L/AUTO FM
TUN MODE/DISP
AUTO/MAN'L
BA
TREBLE
55
1
0
1
44
22
3
3
+
–
BALANCE
55
1
0
1
44
22
3
3
R
L
LOUDNESS
57
1
FLAT
6
48
210
–
30dB
3 9
0
12
12
2
8
4
∞
20
20
60
60
26
26
40
40
16
16
-dB
-dB
DISPLAY
512 43870A6CB9
GFEHIJKLM
D
(U.S.A. model)
Note
Memory back-up
The memory back-up circuit prevents the stored data
from being lost. However, the stored data will be lost if
the power cord is disconnected from the AC wall outlet
for more than one week.
Notes
Note
Notes
Note