Filter
Top Products
36
ADVANCED SETUP
3 Press the preset station/channel number
buttons (1 and 2) on the front panel
repeatedly to move through the menu and
select the parameter you want to adjust.
See page 35 for a complete list of available
parameters.
4 Press A/B/C/D/E on the front panel
repeatedly to toggle between the available
parameters.
5 Press MASTER ON/OFF to release it outward
to the OFF position to confirm your setting.
The settings you made are reflected next time you turn on the
power of this unit.
You can select the unit you want to operate with the
remote control by switching the remote control ID.
1 Press and hold CODE SET on the remote
control and then press TUNER on the remote
control.
2 While holding down CODE SET on the
remote control, use the numeric buttons on
the remote control to enter the three-digit
code number listed in the table below.
*
When you change the remote control ID, you must switch
the remote control ID of this unit (see page 35).
When using multiple YAMAHA receivers or
amplifiers with the same default code setting, you
may unwantedly operate those components
simultaneously. In this case, set one of the alternative
codes for this unit to operate this unit separately.
Also change the remote control ID of the Zone 2 remote control
(sold separately) (see page 9).
Note
1 2
A/B/C/D/E
CATEGORY
MASTER
ON OFF
Switching the remote control ID
Remote
control ID*
(this unit’s
setting)
Function Code number
ID1
To operate this
unit using an
alternative code.
801
ID2
(default setting)
To operate this
unit using the
default code.
802
Note
MENU
CODE SET
STANDBY
POWER
CD
MD/TAPE
TUNER
PHONODVD
POWER POWER
AVTV
VCR
DTV/CBL
XM
MENU
CODE SET
MENUTITLE
SRCH MODE
BAND
A-E/CAT. A-E/CAT.
PRESET/CH
4321
8
10
7
09
65
ENT.
DISPLAYRETURN
MEMORY
ENTER