19
1 Stop the unit.
2 If you will program tracks from more than one disc on
the disc tray, make this unit display the total recorded
time of each disc to be used in turn by pressing the
DISC SKIP button.
* This unit will read the contents of a disc by this
operation. If there is a disc to which this operation is
omitted, tracks on the disc cannot be programmed.
3 Follow step 4 and 5 on page 18.
4
5 If necessary,
select the
desired disc.
6 Select the
desired track.
7 Repeat step 5 and 6 to program more tracks for side
A of the tape. You can select the same track again.
* If “E rr” appears in the display, the track number just
selected cannot be programmed because there is not
enough time remaining on side A of the tape.
8 After you finish the programming for side A, program
the pause mode by pressing the TAPE button.
* “Pu” flashes in the display, and after then you can begin
programming for side B.
9 Follow step 5 and 6.
10 Repeat step 5 and 6 to program more tracks for
side B of the tape.
You can select the same track again.
* If “E rr” appears in the display, the track number just
selected cannot be programmed because there is not
enough time remaining on side B of the tape.
11 The peak level searching function of this unit is
useful for adjusting recording level on the tape
deck. For peak level searching, when the
programming for side B is finished, press the PROG
button and then press the PEAK button on the front
panel.
12 Begin recording on the tape deck and press the
PLAY button on this unit at the same time.
13 The unit will pause at the end of side A of the tape.
Turn the tape over to side B. Resume recording
and, at the same time, press the PLAY or PAUSE
button on this unit.
Notes
●
In step 7 and 10, even if “E rr” appears in the display, you
can program another track of which time is shorter than the
remaining time on the side of the tape. In this case, you can
check the remaining time on the side of the tape by pressing
the TIME display mode-select button.
●
CD synchronized recording function can be used if your tape
deck is compatible with it.
In this case, in step 12 and 13, press the SYNCHRO button
and then press the PLAY button on this unit’s remote control
transmitter. Recording automatically begins.
(For details, refer to page 17.)
Notes on tape programming
●
To check, cancel or correct program data, refer to page 15.
●
The maximum number of tracks that can be programmed is
40. If, however, the PAUSE mode is inserted, it is counted
as one track.
●
This function can be used to program up to track number 20.
If the disc has more than 20 tracks, track number 21 and
thereafter will not be programmed.
■ Manual tape programming
This is for recording desired tracks selected
from one or more discs in any desired order onto tape.
4, 11
2, 5
13
12, 13
DIMMER
TIME
OPEN/CLOSE
PROG
REPEAT
RANDOM
123
4
56
7890
SKIP
PLAY
PAUSE
SEARCH
STOP
INDEX
TAPE
DISC SKIP
DISC
SCAN
10
+
MODE
OUTPUT LEVEL
+
–
SYNCHRO
1
4, 6
8
5
TAPE
PROG
DISC SKIP
REMAIN
TOTAL
PROG
STOP