Yamaha CDC-555 Stereo System User Manual


 
17
1 Select the disc.
2 Load a tape on the tape deck.
CDC-655 only
* The peak level searching function of this unit is useful
for adjusting recording level on the tape deck. (Refer
to page 21.)
3
This unit enters into the pause mode, and the tape deck
enters into the REC/PAUSE mode.
* In this mode, the time display on this unit flashes on
and off.
4 If desired, select the track to be recorded first.
5
Both CD play and tape deck recording begin.
* CD play begins a little later than recording.
6 If you want to stop recording temporarily and restart
recording from a desired track, follow steps 3–5 again.
To cancel this function
Press the STOP button.
Notes
To finish or stop the recording, press the “STOP” button on
the tape deck.
Programmed sequence of tracks can also be recorded with
this function, instead of recording an entire disc. (Refer to
page 14–15 for the programming procedure.)
CDC-655 only
This function can also be used together with the automatic
tape-programming function. (Refer to page 18–20.)
This unit can make a tape deck’s recording synchronized with CD play automatically. With this function, you can record a CD on
tape very easily and more precisely.
This recording method needs a YAMAHA tape deck compatible with this function. (Refer to the tape deck’s operation manual to
know whether it is compatible or not.)
* This unit and the tape deck must be placed close to each other so that both of them can receive the signals from this unit’s
remote control transmitter at the same time.
PLAY
SYNCHRO
CD SYNCHRONIZED RECORDING
DISC SKIP
DIMMER
TIME
OPEN/CLOSE
PROG
REPEAT
RANDOM
123
4
56
7890
SKIP
PLAY
PAUSE
SEARCH
STOP
INDEX
TAPE
DISC SKIP
DISC
SCAN
10
+
MODE
4
4
5
OUTPUT LEVEL
+
SYNCHRO
3
1
5
SKIP
or
4
5
DIMMER
TIME
OPEN/CLOSE
PROG
REPEAT
RANDOM
123
4
56
7890
SKIP
PLAY
PAUSE
SEARCH
STOP
INDEX
CLEAR
SYNCHRO
DISC SKIP
DISC
SCAN
10
+
MODE
1
3
4
CDC-655
CDC-555