Filter
Top Products
POWER
RDS MODE/FREQ PTY SEEK
MODE START AUTO/MAN'L MONO
EON FM/AM TUNING MODE
1
MEMORY
EDIT
MAN'L/AUTO FM
A/B/C/D/E
2
PRESET STATIONS
3
TUNING
PTY SELECTOR
4
5678
9
English
1 Turn the power on.
2 Select the reception band (FM or AM) confirming it on
the display.
3
4 Tune to a desired station.
To tune to a higher frequency, slightly turn the control to
the right. To tune to a lower frequency, slightly turn the
control to the left.
5 If the station where tuning search stopped is not the
desired one, turn again.
* If the tuning search does not stop at the desired station
(because the signals of the station are weak), change
to the MANUAL TUNING method.
1 Turn the power on.
2 Select the reception band (FM or AM) confirming it on
the display.
3
4 Tune to a desired station manually.
Normally, if station signals are strong and there is no interference, quick automatic-search tuning (AUTOMATIC TUNING) is
possible. However, if signals of the station you want to select are weak, you must tune to it manually (MANUAL TUNING).
TUNING OPERATIONS
POWER
FM/AM
AUTO/MAN'L MONO
TUNING MODE
MHz
0
20
l00
AUTO
TUNING
PTY SELECTOR
TUNING
PTY SELECTOR
1
2
3
4, 5
or
AUTOMATIC TUNING
Notes
●
When tuned in to a station, the frequency of the received
station is shown on the display. If an RDS station that
employs PS data service is received, the frequency is then
replaced by the station name. Refer to page 15 for details.
●
If you tune to an FM station manually, it is received in
monaural mode automatically to increase the signal quality.
To turn off the power
Press the POWER switch again.
POWER
FM/AM
MANUAL TUNING
or
AUTO/MAN'L MONO
TUNING MODE
MHz
0
20
l00
TUNING
PTY SELECTOR
Turn “AUTO” off.