Filter
Top Products
4, 22
10
1 Tune to a desired station.
(Refer to the previous page for tuning procedure.)
2 Select a desired group (A – E) of preset stations
confirming it on the display.
3
4
Select a preset station number where you want to program
the station before “MEMO” goes off from the display.
* In the same way, program other stations to A2, A3 ... A8.
* You can program more stations to preset station numbers
on other groups in the same way by selecting other
groups in step 2.
11 Select the group of preset stations.
22 Select the preset station number.
Notes
●
A new setting can be programmed in place of the former
one.
●
For presets, the setting of the reception mode (stereo or
monaural) is stored along with the station frequency.
Memory back-up
The memory back-up circuit prevents the programmed data
from being lost even if the POWER switch is set off or the
power plug is disconnected from the AC outlet or the power is
cut due to temporary power failure. If, however, the power is
cut for more than one week, the memory may be erased. If
so, it can be re-programmed by simply following the PRESET
TUNING steps.
MANUAL PRESET TUNING
This unit can store station frequencies (selected by tuning operation) by using the PRESET STATIONS buttons. With this function,
you can recall any desired station by only pressing the corresponding PRESET STATIONS button. Up to 40 stations (8 stations x 5
groups) can be stored.
PRESET TUNING
To store stations
To recall a preset station
POWER
RDS MODE/FREQ PTY SEEK
MODE START AUTO/MAN'L MONO
EON FM/AM TUNING MODE
1
MEMORY
EDIT
MAN'L/AUTO FM
A/B/C/D/E
2
PRESET STATIONS
3
TUNING
PTY SELECTOR
4
5678
3
2, 11
A/B/C/D/E
MEMORY
MAN'L/AUTO FM
MEMO
A/B/C/D/E
Flashes on and off
for about 5 seconds.
12
PRESET STATIONS
34
5678
12
PRESET STATIONS
34
5678
MHz
PS
0
20
l00
RT CTPTY
Shows the displayed station has been
programmed to A1.