Filter
Top Products
This unit allows you to switch the input mode for sources that
send two or more types of signals to this unit.
The following three input modes are provided.
AUTO
This mode is automatically selected when you turn on the
power of this unit.
In this mode, input signal is automatically selected by the
following order of priority.
1. Digital signal encoded with Dolby Digital or DTS, or normal
digital input signals (PCM)
2. Analog input signal (ANALOG)
* For a DVD/LD source, if digital signals are input from both
of the OPTICAL and COAXIAL terminals, the digital signal
from the COAXIAL terminal is selected.
DTS
In this mode, only digital input signals encoded with DTS is
selected even though other signals are input at the same time.
ANALOG
In this mode, only analog input signals are selected even
though digital signals are input at the same time.
Select this mode when you want to use analog input signals
instead of digital input signals.
Notes on input mode selection
●
The input mode for a TV/DBS source is selected with
function “12. TV/DBS INPUT” in the SET MENU mode.
This unit will be automatically set to the selected input mode
when the power is turned on.
●
Set the input mode to the AUTO mode to play a DVD/LD
source encoded with Dolby Digital.
●
Select the ANALOG mode to play a normal 2-channel
source with a Dolby Pro Logic Surround program.
●
The sound output may be interrupted in some LD and DVD
players in the following situation:
The input mode is set to AUTO. A search is made while
playing the disc encoded with Dolby Digital or DTS, then
disc playing is restored. The sound output is interrupted for
a moment because the digital input signal was selected
again.
●
The input mode cannot be changed for PHONO, TUNER,
TAPE/MD, VCR and VIDEO AUX sources because only
analog signals are used.
●
The present input mode appears on the front display and
monitor screen when the input source is changed to
DVD/LD, CD or TV/DBS, or the input mode is changed.
The present input signal is also shown on the monitor
screen when the input mode is changed to AUTO, as shown
below.
* However, the present input signal will not be shown when
the input mode is switched during the speaker test mode.
Only AUTO will be displayed.
Notes on playing a source encoded with DTS
●
Select the DTS mode when playing an LD or CD source
encoded with DTS. (Red “dts” indicator is illuminated on
the display panel.) If the “AUTO” mode is selected, a
noise may be heard just after playback begins.
Do not play these sources in the ANALOG mode
because only background noise will be output from the
speakers.
●
This unit is automatically locked in the DTS decoding
mode when playing a CD or LD source encoded with
DTS in the AUTO mode to prevent background noise in
future operation. The red “dts” indicator will be flashing.
In this mode, no sound will be heard if a disc with normal
digital signals (PCM) is played from a CD or LD source.
To play back the disc normally, press the INPUT MODE
button on the front panel, or, the input selector key for the
current source on the remote controller.
36
BASIC OPERATION
Ⅵ Switching the input mode for the CD, DVD/LD and TV/DBS sources