Filter
Top Products
76
REMOTE CONTROL FEATURES
You can control other components by setting the
appropriate manufacturer codes. Codes can be set up for
each input area.
The following table shows the factory preset component
(Library: component category) and the manufacturer code
for each area.
Remote Control Code Default Settings
You may not be able to operate your YAMAHA component even
if a YAMAHA remote control code is initially set as listed above.
In this case, try to set other YAMAHA remote control code(s).
1 Press an input selector button to select the
source component you want to set up.
2 Press and hold LEARN for about 3 seconds
using a ballpoint pen or similar object.
“SETUP” and the selected component name appear
alternately in the display window.
Be sure to press and hold LEARN for at least 3
seconds, otherwise the learning process will start.
y
Complete each of the following steps in 30 seconds.
Otherwise, the learning mode will be automatically
canceled. In this case, press LEARN again.
If you want to change a library (component
category), press j / i. You can set a different
type of component.
Library choices: L:DVD, L:DVR, L:LD, L:CD,
L:CDR, L:MD, L:TAP (tape), L:TUN, L:AMP*,
L:TV, L:CAB (cable), L:DBS, L:SAT, L:VCR
• The amplifier Library (L:AMP) code is preset to “ID1” to
operate this unit. However, you can switch between the
following two codes if necessary.
The initial setting for “Amplifier library” is “ID1”.
When using multiple YAMAHA receivers/amplifiers, you may be
able to operate the other components simultaneously with the
default code setting. In this case, set one of the alternative codes
to operate this unit separately
Setting remote control codes
Input area
Component
category
(Library)
Manufacturer
ALD
Yamaha (U.K. and Europe models)
Yamaha-1 (Other models)
B CD-R Yamaha
PHONO TV –
V-AUX VCR –
TUNER TUNER
Yamaha-3 (U.K. and Europe models)
Yamaha-4 (Other models)
MD/CD-R MD Yamaha-1
CD CD Yamaha-1
DTV/CBL TV –
VCR 1 VCR –
DVR/VCR2 DVR Yamaha
DVD DVD Yamaha-1
Note
AB
PHONO
CDMD/CD-RTUNERV-AUX
DVDVCR 1DTV/CBL DVR/VCR2
MULTI CH IN
AMP library
code
(remote
control
setting)
Function
Remote
control ID
(this unit’s
setting: see
page 74)
ID1
(initial setting)
To operate this unit using the
default code.
ID1
(initial
setting)
ID1Z To operate this unit using the
default code.
To operate Zone 2 or Zone 3
features (see page 83).
(U.S.A., Canada, Europe and
Australia models only)
ID2
To operate this unit using an
alternative code.
ID2
ID2Z
To operate this unit using an
alternative code.
To operate Zone 2 or Zone 3
features (see page 83).
(U.S.A., Canada, Europe and
Australia models only)
LEARN