Filter
Top Products
27
AUTO SETUP
PREPARATION
■ If a warning screen appears
1 Press ENTER to display detailed information
about the warning.
Press j / i to switch between warning messages.
For details about each message, see page 29.
y
• Warnings let you know about potential problems detected
during auto setup. Warnings will not cancel the auto setup.
• The number of warnings is displayed to the right of
“WARNING”.
• When the warning is not applicable to a speaker, “– –” is
displayed.
2 When you are finished, press ENTER to
return to the RESULT:EXIT screen.
Continue from step 7 on page 26.
• If you change speakers, speaker positions, or the layout of your
listening environment, perform auto setup again to re-calibrate
your system.
• Depending on listening environments, SWFR PHASE:REV
appears in AUTO:CHECK and SUBWOOFER PHASE
parameter in the SETMENU (see page 66) is automatically set
to REVERSE. To select the desired setting, change the
SUBWOOFER PHASE parameter in the SETMENU.
• In the DISTANCE results, the distance displayed may be longer
than the actual distance depending on the characteristics of your
subwoofer.
Notes
WARNING:W-1
.<OUT OF PHASE>
.Reverse Channel
.FL __
.CENTER
.PL PR
.SL SR
.SBL SBR
[<]/[>]:Select
[ENTER]:Return
.WARNING (3)
RESULT
SP : 5/4/0.1
DIST: 10.0/ 12.0ft
LVL : -9.0/ +6.5dB
.>SET CANCEL
[]/[]:Up/Down
[ENTER]:Enter
p
p
RESULT:EXIT
W-1 example screen