Filter
Top Products
48
You can use this remote control transmitter to control not only this unit but also other components connected to it. This is factory
set to control this unit and most YAMAHA audio components. To control other brands of components, you must preset the remote
control transmitter with the manufacturer’s codes listed on pages 397 to 402.
2 Press the desired operation button.
Note: Press the button with the remote control transmitter
aimed at the front panel.
REMOTE CONTROL TRANSMITTER
Basic Operations
1 Select the component that you want to control by turning
the SELECTOR DIAL.
Note: Turn the SELECTOR DIAL until it stops with a click.
Components which can be controlled
There are nine positions that you can select to control connected components with this remote control transmitter. When turning
the SELECTOR DIAL, the position changes as follows:
SELECTOR
DIAL
Notes
1. The shaded positions in the diagram above indicate that you can preset the code for the manufacturer of your component.
Note that you can preset only one code for one position. For details, see “SETUP CODES” on page 53.
2. The DVD/LD and DVD MENU positions
• Be sure that the SELECTOR DIAL is set to the DVD/LD position when presetting the code for a DVD or an LD player. The
code that you preset to the DVD/LD position is also preset to the DVD MENU position simultaneously. You cannot preset the
code for a DVD player when the SELECTOR DIAL is set to the DVD MENU position.
• DVD MENU operations cannot be performed for some DVD players.
3. When using a second (and third) VCR (For details, see “To use a second (and third) VCR” on page 53.)
• If you are not using a CBL/DBS (cable TV or DBS tuner), the second (or third) VCR can be preset using the CBL/DBS
position.
• If you are not using a DVD player, the second (or third) VCR can be preset using the DVD MENU position. Note that in this
case you must preset a code for an LD player to the DVD/LD position even if an LD player is not used.
DVD/LD & DVD MENU:
An LD player can be controlled using the DVD/LD position.
A DVD player can be controlled using the DVD/LD and DVD
MENU positions. When using the YAMAHA DVD player
(DVD-1000 or DVD-S700), be sure to preset the code number
“4490”.
AMP/TUN:
You can perform basic opera-
tions of this unit with the
SELECTOR DIAL set to this
position.
TAPE/MD:
The code for a YAMAHA tape deck is preset.
(Be sure to preset the proper code when operating a YAMAHA
MD recorder.)
CD:
The code for a YAMAHA CD player is preset.
DSP:
This unit can be controlled and DSP programs can be selected
directly.
VCR:
A VCR can be controlled.
CBL/DBS:
A cable television or
DBS tuner can be
controlled.
TV:
A television can be
controlled.
Indicator
The indicator will flash when the button
is pressed.
The component name is
displayed in this window.
01RX-V595RDS-6 6/23/99, 1:13 PM48