Filter
Top Products
29
English
AUTOMATIC TUNING
1 Select the reception band (FM or AM) confirming it on
the display.
Front panel
or
2 Press TUNING MODE (so that the “AUTO TUNING”
indicator lights up on the display).
Front panel
Lights up.
3 To tune in to a higher frequency, press the UP side of
TUNING once.
To tune in to a lower frequency, press the DOWN side
of TUNING once.
Front panel
* If the station where the tuning search stops is not the
desired one, press once more.
* If the tuning search does not stop at the desired station
(because the signal from the station is weak), operate the
manual tuning procedure.
TUNING OPERATIONS
Set the SELECTOR DIAL to the AMP/TUN position on the remote control transmitter and select the tuner by using INPUT.
Normally, if station signals are strong and there is no interference, quick automatic-search tuning (AUTOMATIC TUNING) is
possible. However, if the signal from the station you want to select is weak, you must tune in to it manually (MANUAL TUNING).
MANUAL TUNING
1 Select the reception band (FM or AM) confirming it on
the display.
Front panel
or
2 Press TUNING MODE.
Front panel
3 Tune in to the desired station manually.
Front panel
* To continue the tuning search, press and hold the button.
Notes
• If you tune in to an FM station manually, it is received in
monaural mode automatically to increase the signal quality.
• If an RDS station that employs PS data service is received,
the station name is shown on the display.
2 3
1
Confirm that the “AUTO
TUNING” indicator goes off.
01RX-V595RDS-3 6/23/99, 1:12 PM29