Filter
Top Products
10
CENTER MODE
+
DELAY
TIME
–
ŸPRO LOGIC–ENHANCED
CNCT VIDEO
MONO MOVIE ROCK HALL
EFFECT
–
VOLUME
+
ŸSURROUND
ADJUSTMENT BEFORE OPERATION
0
VOLUME
–dB
2 Select the front speakers to be used.
SPEAKERS
A B
ON _ ON
OFF — OFF
÷ If you use two front speaker systems, press both the
A and B switches.
DEFEAT
5+
–5
BASS
DEFEAT
5+
–5
TREBLE
4 Set the BALANCE control to the 0 position.
5R
L5
BALANCE
0
POWER
6 Select the ŸPRO LOGIC or ENHANCED mode.
ŸPRO LOGIC — ENHANCED
÷ The PROGRAM button on the front panel can also be
used instead of the ŸPRO LOGIC or ENHANCED
button on the remote control transmitter. Turn on the
EFFECT button and then press the £ or ™ side of
the PROGRAM button so that the ŸPRO LOGIC or
ENHANCED indicator lights on the display.
Speaker balance adjustment
This procedure lets you adjust the sound output level balance between the front, center, and rear speakers using the built-in
test tone generator. With this adjustment, the sound output level heard at the listening position will be the same from each
speaker. This is important for the best performance of the digital sound field processor.
6
7
4325
61
1 Turn off the power and set the VOLUME control to
the “ ” position.
5 Turn on the power.
3 Set the BASS and TREBLE controls to the DEFEAT
position.
7 Select the center mode according to your speaker
configuration by pressing the CENTER MODE button
on the remote control transmitter.
(Refer to “SPEAKER CONFIGURATION” on page 6.)
On the feature of each mode, refer to “Note” shown
on the next page.
CENTER MODE
NORMAL
ms
NORMAL
WIDE
PHANTOM