Yamaha RXV3000RDS Stereo Receiver User Manual


 
English
67
DSP Parameter
REV. LEVEL (Reverberation Level) Control Range 0 – 100 %
Function .............. This parameter adjusts the volume of the reverberation sound.
Description ......... The larger the value, the stronger the reverberation becomes.
CT. DELAY (Center Delay) Control Range 0 – 50 msec
Function .............. These parameters adjust the sound delay for each channel in 8 channel stereo mode.
LS. DELAY (Left Surround Delay) Control Range 0 – 50 msec
Function .............. These parameters adjust the sound delay for each channel in 8 channel stereo mode.
RC. DELAY (Rear Center Delay) Control Range 0 – 50 msec
Function .............. These parameters adjust the sound delay for each channel in 8 channel stereo mode.
RS. DELAY (Right Surround Delay) Control Range 0 – 50 msec
Function .............. These parameters adjust the sound delay for each channel in 8 channel stereo mode.
FL. DELAY (Front Left Delay) Control Range 0 – 50 msec
Function .............. These parameters adjust the sound delay for each channel in 8 channel stereo mode.
FR. DELAY (Front Right Delay) Control Range 0 – 50 msec
Function .............. These parameters adjust the sound delay for each channel in 8 channel stereo mode.
Level
Sound Source
REV. LEVEL
Time
Resetting to the Factory Preset Value
To reset a parameter to the factory preset value
Select the parameter you want to reset. Then, press and hold + or until the value stops at the factory preset value temporarily. (The
asterisk mark by the parameter name disappears on the video monitor.)
To reset all of the parameters back to the factory preset values
Use the SET MENU to reset all of the parameter values of all DSP programs within the selected group to the factory preset values. This
operation resets all of the parameter values of all DSP programs within that group to the factory preset values.
Notes:
The available parameters may be displayed on more than one OSD page for some of the programs. To scroll through pages, press g or h.
When “MEMORY GUARD!” appears on the screen, the Memory Guard function is on, and you cannot change parameter values. Turn off the
Memory Guard function using the SET MENU.