Filter
Top Products
IntroductionPreparationsBasic Operation
Advanced
Operation
Additional
Information
Appendix
56
Remote Control Features
Clearing Learned Functions and Setups
1
1
Press CLEAR using a ballpoint pen or similar object.
2
2
Press h/g to select the mode to be cleared. The mode is
shown in the window in the following order:
(L: name of a component) Clears all learning functions of
the component.
Clears all learning functions of the main unit control area.
Clears all learning functions.
Clears all macros.
Clears all renamed displays in the display window.
Clears all programmed functions including manufacturer
code presets. This returns to the factory presets.
3
3
Press and hold CLEAR again for about 3 seconds.
• “C:NG” appears in the display window if the operation is
unsuccessful.
4
4
Press CLEAR to confirm clearing.
• Once you clear a learned function or macro from a button,
the button reverts to its factory preset function or macro.
Notes:
• If the remote control is without batteries for more than twenty minutes, or if worn out batteries remain in the unit, the contents of the memory may be
cleared. When the memory is cleared, insert new batteries and program any acquired functions that may have been cleared.
• “ERROR” appears in the display window for the following conditions: when pressing a button other than the cursor and ENTER; when pressing more
than one button at once; and when one of MACRO ON/OFF, 10KEY/DSP, PARAMETER/SET MENU is switched to another position.
CLEAR
CLEAR
CLEAR
For example, when DVD is selected as
the source component.