Filter
Top Products
21 En
Connections
English
PREPARATION
1 Press
A
STANDBY/ON on the front panel to
set this unit to the standby mode.
Refer to the right column for details.
2 Press and hold
K
TONE CONTROL and
then press
A
STANDBY/ON to turn on this
unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3 Press
L
PROGRAM l / h to select “SP
IMP.”.
“SP IMP.” and the current speaker impedance setting
(“8Ω MIN”) appear in the front panel display.
4 Press
M
STRAIGHT repeatedly to select
“6Ω MIN”.
5 Press
A
STANDBY/ON to save the new
setting and turn off this unit.
The setting you made is reflected next time you turn on this unit.
■ Turning on this unit
Press
A
STANDBY/ON (or
H
POWER) to turn
on this unit.
y
When you turn on this unit, there will be a 4 to 5-second delay
before this unit can reproduce sound.
■ Set this unit to the standby mode
Press
A
STANDBY/ON (or
I
STANDBY) to set
this unit to the standby mode.
In the standby mode, this unit consumes a small amount of
power in order to receive infrared signals from the remote
control.
Setting the speaker impedance
Caution
If you are to use 6 ohm speakers, set “SP IMP.” to
“6Ω MIN” as follows BEFORE using this unit.
Note
TONE CONTROL
STANDBY
/ON
While holding
down
Turning on and off the power
01EN_HTR-6140_U.book Page 21 Friday, February 1, 2008 2:26 PM