Filter
Top Products
28
PLAYBACK
■ Displaying information about the input
source
You can display the format, sampling frequency, channel
and bit rate of the current input signal.
1 Press one of the input selector buttons on
the remote control to select the desired input
source.
2 Press AMP on the remote control and then
press STRAIGHT to select “STRAIGHT”.
3 Press u / d to display the following
information about the input source.
FORMAT
Signal format display. When this unit cannot detect a
digital signal, it automatically switches to analog
input.
Display status: Analog, Digital, Dolby Digital, DTS,
PCM, Unknown Digital
“Unknown Digital” appears when this unit detects any
undecodable digital signal.
CHANNEL
Number of source channels in the input signal (front/
surround/LFE). For example, a multi-channel
soundtrack with 3 front channels, 2 surround
channels and LFE, is displayed as “3/2/LFE”.
SAMPLING
Sampling frequency.
Display status: 32kHz, 44.1kHz, 48kHz, 64kHz,
88.2kHz, 96kHz
BITRATE
Bit rate.
y
When you are displaying information about the input source, this
unit is in the “STRAIGHT” mode (see page 33). To turn back the
sound field program on, press STRAIGHT again.
AMP
ENT.
STRAIGHT
ENTER
PRESET/CH
A-E/CAT.
+
–
Note