Filter
Top Products
19
CONNECTIONS
PREPARATION
Once all connections are complete, plug the power cable
into the AC wall outlet.
IMPEDANCE SELECTOR
(U.S.A. and Canada models only)
Before connecting the power cable into the AC wall outlet,
check that the impedance selector setting is correct.
VOLTAGE SELECTOR
(Asia and General models only)
The VOLTAGE SELECTOR on the rear panel of this unit
must be set for your local voltage BEFORE plugging the
power cable into the AC wall outlet. Improper setting of
the VOLTAGE SELECTOR may cause damage to this
unit and create a potential fire hazard.
Select the switch position (upper or lower)
according to your local voltage using a straight
slot screwdriver.
Voltages are 110-120/220-240 V AC, 50/60 Hz.
When all connections are complete, turn on this unit.
Press STANDBY/ON on the front panel (or
POWER on the remote control) to turn on this
unit.
Press STANDBY/ON on the front panel again (or press
STANDBY on the remote control) to set this unit to the
standby mode.
Connecting the power cable
CAUTION
IMPEDANCE SELECTOR
(U.S.A. model)
Power cable
110V-120V
220V-240V
VOLTAGE
SELECTOR
Turning on the power
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is in the standby mode.
However, the stored data will be lost in case the power
cable is disconnected from the AC wall outlet or if the
power supply is cut off for more than one week.
PRESET/TUNING/CH
VOLUME
STANDBY
/ON
PHONES
SILENT CINEMA
SPEAKERS
A/B/OFF
FM/AMPRESET/TUNING
A/B/C/D/E
lh
NEXT
AUTO/MAN'LMAN'L/AUTO FM
MEMORY
TUNING MODE
EFFECT
STRAIGHT
TONE CONTROL
BASS/TREBLE
l PROGRAM h
EDIT
INPUT MODE
l INPUT h
MULTI CH INPUT
SET MENU
SEARCH MODE
XM
CATEGORY
DISPLAY
POWER
TV
TV
AMP
CODE SET
REC
MULTI CH IN
DISC SKIP
V-A UXVCRDTV/CBLDV D
SLEEPTUNERMD/CD-RCD
POWER
STANDBY
POWERPOWER
AVTV
AUDI O
+++
STANDBY/ON
POWER
STANDBY
/ON
POWER
or
Front panel
Remote control