Filter
Top Products
GETTING STARTED
18 En
■ Inserting batteries into the
remote control
1 Open the battery compartment.
2 Insert two batteries type R06 or AA, following the
indications (+/–) inside the compartment.
3 Close the battery compartment.
To replace the batteries
If the batteries grow old, the effective operation
distance of the remote control decreases considerably.
If this happens, replace the batteries with two new
ones as soon as possible.
– Insert batteries correctly according to the polarity
markings (+/–). The batteries inserted in the opposite
direction may leak.
– Replace the exhausted batteries immediately with new
ones to prevent a leakage.
– Remove the batteries from the compartment if the remote
control is not used for more than a month.
– If the batteries have leaked, dispose of them immediately.
Avoid touching the leaked material or letting it come into
contact with clothing, etc. Clean the battery compartment
thoroughly before installing new batteries.
– Do not use old batteries together with new ones.
– Do not use different types of batteries (such as alkaline
and manganese batteries) together. Read the packaging
carefully as these different types of batteries may have the
same shape and color.
– Dispose of the batteries correctly in accordance with your
local regulations.
■ Using the remote control
Use the remote control within 6 m (20 ft approx.) of
the DVD receiver and point it toward the remote
control sensor.
Handling the remote control
• Do not spill water or other liquids on the remote
control.
• Do not drop the remote control.
• Do not leave or store the remote control in the
following types of conditions:
– places of high humidity, such as near a bath
– places of high temperature, such as near a heater or stove
– places of extremely low temperatures
– dusty places
GETTING STARTED
Notes
If the remote control is without batteries for more than
2 minutes, or if exhausted batteries remain in the
remote control, the contents of the memory may be
cleared. When the memory is cleared, insert new
batteries and reset the remote control codes.
When changing the batteries, be careful not to press
any of the buttons on the remote control. Doing so will
clear the contents of the memory.
1
3
2
Within 6 m
(20ft approx.)
01EN_DVX-C310_UC.book Page 18 Monday, July 10, 2006 11:22 AM