Filter
Top Products
24
Preparations
Connecting Power Supply Cords
■ Connecting the AC Power Cord
After completing all connections, plug the AC power cord into a convenient AC
outlet.
■ AC OUTLETS
Use these to connect the power cords from your other components to this unit.
The power to the switched outlets is controlled by this unit’s STANDBY/ON
(SYSTEM POWER ON or STANDBY on the remote). These outlets will
supply power to any connected unit whenever this unit is turned on. The
maximum power (total power consumption of components) that can be connected
to AC OUTLETS is 100W.
■ VOLTAGE SELECTOR (General and China Models)
The voltage selector on the rear panel of this unit must be set for your local
voltage before plugging into the AC main supply.
Voltages are 110/120/220/240 V AC, 50/60 Hz.
AC OUTLETS
IMPEDANCE SELECTOR
VOLTAGE SELECTOR
Hookups
Connecting an External Decoder
The DSP-AX1 is equipped with six additional input jacks (left and right MAIN, CENTER, left and right SURROUND and SUBWOOFER)
for discrete multi-channel input from an external decoder, sound processor, or pre-amplifier.
Connect the output jacks on your external decoder to the 6CH
INPUT jacks.
Be sure to match the left and right outputs to the left and right input jacks for
the main and surround channels.
To listen to the sound from your external decoder, press 6CH INPUT on this
unit or the remote control.
Note:
• When you select 6CH INPUT as the input source, this unit automatically turns off
the digital sound field processor, and you cannot listen to DSP programs.
MAIN
CENTER
SUB
WOOFER
6CH INPUT
SURROUND
DVD
LD
VCR 1
D-TV
CBL
/SAT
ZONE 2 OUT VIDEO
OUT
DIGITAL
L
R
L
R
C
C
(General Model)
Subwoofer Output
External Decoder
Center Output
Main Output
Surround Output
AC Power Cord
AC OUTLETS
VOLTAGE
SELECTOR