Yamaha CRX-E500 CD Player User Manual


 
7
GETTING STARTED
Setting the clock
You must set the clock before you use the timer functions.
The clock is based on a 12-hour system for U.S. and
Canada models, and 24-hour system for Australia model.
1 Turn on the power by pressing STANDBY/ON on
the front panel, or POWER on the remote control.
2 While the power is on, press DISPLAY to display
the time.
3 While holding TIME ADJ, press HOUR to set the
hour.
If you want to move the time in the reverse
direction, press HOUR while holding TIME ADJ
and PRESET/BAND.
4 While holding TIME ADJ, press MIN to set the
minutes.
If you want to move the time in the reverse
direction, press MIN while holding TIME ADJ
and PRESET/BAND.
To display the clock
Press DISPLAY.
The current time appears for about 8 seconds, then the
normal display returns. Some buttons and controls may
not work while the current time is displayed.
Note
In the event of a power failure or when the AC power cord is
disconnected for more than five minutes, you must reset the
clock.
Adjusting the brightness
of the display
You can adjust the brightness of the display. If you have
connected the CD player (CDC-E500), cassette deck
(KX-E300), and/or MD recorder (MDX-E300) to this
unit, the brightness of the displays is automatically
adjusted to that of this unit.
Press and hold DISPLAY for about two seconds so that
Dimmer ±0 appears on the display. While holding
DISPLAY, turn INPUT clockwise to increase or
counterclockwise to decrease brightness.
Control Range: ±0 to 6 (Preset value: ±0)
HOUR
DISPLAY
PRESET/BANDTIME ADJ
MIN
INPUT
DISPLAY
BALANCE
INPUT
VOLUME
L
R
TREBLEBASS
PHONES
STANDBY/ON
TIMER
DISPLAY MEMORY
NATURAL SOUND
STEREO RECEIVER
RXE400
AUTO/MAN'L
PRESET/BAND
TIMER HOUR MIN
MIN MAX
PRESET/TUNING
TIMER ADJ
+ +
BALANCE
INPUT
VOLUME
L
R
TREBLEBASS
PHONES
STANDBY/ON
TIMER
DISPLAY MEMORY
NATURAL SOUND
STEREO RECEIVER
RXE400
AUTO/MAN'L
PRESET/BAND
TIMER HOUR MIN
MIN MAX
PRESET/TUNING
TIMER ADJ
+ +
STANDBY/ON
0104CRXE500(U).03-09.E 02.7.9, 4:40 PM7