Filter
Top Products
Chapter 1 - System Configuration
3
Chapter 1 - System Configuration
Before using the CRW4261t, make sure that you have all of the items
on the list of included items.
In order to use the CRW4261t, you will require the following.
Computer
The following operating environment is required:
• An IBM/AT compatible computer with a 100 MHz or faster Pentium
CPU (in order to write at 4x speed), or a 100 MHz or faster 486 CPU
(in order to write at 2x speed)
• A vacant IDE interface connector
• A vacant half-height bay
• Windows 95, Windows NT4.0 or Higher
• Sufficient hard disk space
Note:
You will need about twice as much space on your hard disk as that
required by the data you wish to write to CD-ROM.
Software
Use writing software or packet writing software which supports the
CRW4261t.
Tools
Phillips screwdriver
This is used to remove the
cover of your computer,
and to install the Yamaha CRW4261t drive.
Long nose pliers
These are used to insert or remove
the jumper pin when setting the
MASTER/SLAVE settings of the
Yamaha CRW4261t drive.
Phillips Screwdriver
Long nose pliers