Filter
Top Products
Chapter 2 - Installing the Yamaha CRW4001t Drive
9
7. Connect the AUDIO cable.
Connect the single 4-pin connector (Sound Blaster compatible) to the
sound card. Connect the 4-pin connector at the other end of the cable (the
larger connector) to the AUDIO OUT connector on the CRW4001t drive.
The polarizing lug should be at the top.
RGL
AUDIO OUT
CSEL
SLAVE
MASTER
SER. NO.
IDE INTERFACE CONNECTOR
1
DC INPUT
+5V G +12V
RGL
AUDIO OUT
CSEL
SLAVE
MASTER
SER. NO.
IDE INTERFACE CONNECTOR
1
DC INPUT
+5V G +12V
To the CRW4001t
4-pin connector (large)
To the CDR100/102
(3-pin connector)
To the Sound Card (Sond Blaster compatible)
4-pin connector (small)
* Simultaneous use with the
CRW4001t is not possible.
AUDIO Cable