Filter
Top Products
14
Refer to the examples of connecting the CRW3200E drive on page 11, and set
the CRW3200E drive to master/slave to support your computer environment.
Use narrow pliers to set the plastic shunt at the jumper
switch on the rear panel.
The position into which the plastic shunt is inserted varies due to the
settings.
2 Set the Jumper Switch
The CRW3200E drive is set at slave by default.
When replacing an IDE device (master) with the CRW3200E drive,
set the drive to master.
Master Slave
(by default)
Continued on next page