Filter
Top Products
Chapter 2 - Installing the Yamaha CRW2216E Drive
6
Setting the CRW2216E as the MASTER
As shown in the diagram at the right, insert the
jumper pin into the right edge of the jumper
switch.
Note:
If only the CRW2216E will be connected to the
IDE interface connector, connect the
CRW2216E to the end of the connector.
Setting the CRW2216E as the SLAVE
As shown in the diagram at the right, insert the
jumper pin into the middle of the jumper
switch.
CSEL (Cable SELect)
If you use the CSEL setting, the MASTER/SLAVE setting will be
made automatically depending on the hardware configuration.
For details refer to the manual of your computer.
CSEL
SLAVE
MASTER
CSEL
SLAVE
MASTER