Setup Procedures
22
Note
Some sound cards may have one or more audio input connectors.
However, depending on your connectors, the specifications may differ from the
CRW2200E
drive. If no sound is audible from the speaker even though the audio cable is connected, refer
to the documentation that came with your sound card for more details, and make sure that
your audio cable is connected correctly.
The ANALOG AUDIO OUT connector of the
CRW2200E
drive is shown in the figure on
the previous page.
Connecting the digital audio cable
The digital connection for the
CRW2200E
drive is ideal for pure quality audio
playback, outputting digital signals recorded on CDs to the sound card without
any distortion.
Examples of the digital connection
To output digital audio signals to external devices, you must use the digital connection to
connect the unit and the sound card. With this connection you can:
• Enjoy music using a digital audio amplifier.
• Record music digitally with an MD player.
Use the digital audio cable to connect the DIGITAL AUDIO OUT connector of
the unit and the SPDIF input connector (digital audio) of the sound card, making
sure of the connector’s direction.
Note
For the digital connection, you need a digital audio cable with appropriate connectors, and a
sound card with SPDIF (digital audio) input connectors.
The DIGITAL AUDIO OUT connector of the
CRW2200E
drive is shown in the figure above.
Digital audio cable
Sound card
Ground (G)
Signal (D)
SPDIF
DIGITAL AUDIO
OUT