Filter
Top Products
English
3
En
Battery installation
1. Turn the remote control over and remove the battery
compartment cover by sliding it in the direction of the
arrow.
2. Insert the batteries (AAA, R03, UM-4) according to the
polarity markings on the inside of the battery
compartment.
3. Close the battery compartment cover.
Battery replacement
If you notice that the remote control must be used closer to
the main unit, the batteries are weak. Replace both
batteries with new ones.
Notes
● Use only AAA, R03, UM-4 batteries for replacement.
● Be sure the polarities are correct. (See the illustration inside
the battery compartment.)
● Remove the batteries if the remote control is not used for an
extended period of time.
● If batteries leak, dispose of them immediately. Avoid touching
the leaked material or letting it come in contact with clothing,
etc. Clean the battery compartment thoroughly before
installing new batteries.
Remote control operation range
Notes
● There should be no large obstacles between the remote control
and the main unit.
● If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type fluorescent lamp etc.), the
remote control might not work properly. In this case,
reposition the main unit to avoid direct lighting.
30°
30°
Remote control Audio pin cable
Batteries (AAA, R03, UM-4) x 2
Carefully remove this unit and accessories from the box. You should find the unit itself and the following accessories.
Remote control
sensor
Within approximately
6 m
(CDX-397)
SEARCH
TIME/INFO
FOLDER
FOLDER
ENTER
FILE
OUTPUT
LEVEL
FILE
SYNCHRO
TAPE
PEAK
SPACE
REPEAT
DIMMER
RANDOM
INDEX
0
9
6
5
8
7
2
1
4
3
OPEN/CLOSE
A–B
PROGRAM
CLEAR
SEARCH
TIME/INFO
SYNCHRO
TAPE
PEAK
SPACE
REPEAT
DIMMER
RANDOM
INDEX
0
9
6
5
8
7
2
1
4
3
OPEN/CLOSE
A–B
PROGRAM
CLEAR
UNPACKING
NOTES ABOUT THE REMOTE CONTROL
Press %
(CDX-497)
01_En_02_BOD_CDX-397_497_G.pm 4/27/06, 3:06 PM3